Filter
Top Products
Configure X2T route
I. Enabling X.25 Swit
c
hing
Before configuring X2T, you must enable X.25 switching.
Perform the following configuration in system view.
Table 5-1 Configure X.25 switching
Operation Command
Enable X.25 switching
x25 switching
Disable X.25 switching
undo x25 switching
5.2.2 Configuring the Interface at the X.25 Network Side
For information about the configuration of the interface at the X.25 network side, see
“Configure X.25” in Chapter 16 of the 3Com Router Configuration Guide.
You do not need to configure an X.121 address when configuring the interface at the
X.25 network side.
I. Configure the Interface at the IP Network Side
For the configuration of the interface at the IP network side, see the Network Protocol
section in the 3Com Router Configuration Guide.
II. Configuring an X.25 Route
Perform the following configuration in system view.
Table 5-2 Configure an X.25 route
Operation Command
Configure an X.25 route
x25 switch svc x.121-address
interface serial number
Delete the X.25 route
undo x25 switch svc x.121-address
[
interface serial number
]
III. Configuring an X2T Route
There are two types of X2T forwarding routes, one from IP network to X.25 network
and the other from IP network to X.25 network.
1) Configuring an X.25-to-IP X2T forwarding route
Perform the following configuration in system view.
Table 5-3 Configure an X.25-to-IP X2T forwarding route
Operation Command
Configure an X.25-to-IP X2T
translate x25 x.121-address ip ip-address port port-number
3Com Router Configuration Guide Addendum for V1.20
57