Filter
Top Products
3Com Router 5000/6000 Family 95
Command Reference
log-peer-change
Use the log-peer-change command to turn on the OSPF adjacency changes output switch for the current
OSPF process.
OSPF view
log startup
Use the log startup command to turn on the configuration restoration log switch.
User view
loopback
Use the loopback command to enable the loopback function on an ATM OC-3c/STM-1 interface.
ATM Interface view
loopback
Use the loopback command to configure the loopback mode on the ATM E1/T1 interface.
ATM E1/T1 Interface views
loopback
Use the loopback command to enable loopback function of interface.
ATM E3/T3 Interface view
loopback
Use the loopback command to enable a serial interface to perform loopback.
AM Interface view
AUX Interface view
Serial Interface view
loopback
Use the loopback command to set the loopback mode on the interface.
CE1/PRI interface view
loopback
Use the loopback command to configure the loopback function of the CPOS interface.
CPOS Interface view
loopback
Use the loopback command to enable loopback on the Ethernet port for test purpose.
Ethernet Port view
loopback
Use the loopback command to configure the loopback function of the POS interface.
POS Interface view
loopback (CE1/PRI Interface)
Use the loopback command to enable a CE1/PRI interface to perform loopback.
CE1/PRI Interface view
loopback (CE3 Interface)
Use the loopback command to configure the loopback mode of a CE3 interface.
CE3 Interface view
loopback (CT1/PRI Interface)
Use the loopback command to enable a CT1/PRI interface to perform local, remote, or external payload
loopback.
CT1/PRI Interface view
loopback (CT3 Interface)
Use the loopback command to configure the loopback mode of the CT3 interface.
CT3 Interface view
loopback (Ethernet/GE Interface)
Use the loopback command to enable local loopback on the Ethernet interface.
Ethernet Interface view
loopback (ISDN BRI Interface)
Use the loopback command to place the B1, B2, or both channels on the BRI interface in a remote looback.
This can send data from a line back to the line.
ISDN BRI Interface view
looptest
Use the looptest command to test whether an interface or line is in a loop.
Any view
lr
Use the lr command to configure LR.
Traffic Behavior view