3Com 5112M-TPLS Tablet User Manual


 
3 - 8 ONline 10BASE-T Security Module Installation and Operation Guide
Installing the Module
You do not need to power down the ONline System Concentrator to install
the Security Module. You can insert the module while the concentrator is
operating (this is called a hot swap).
This section describes:
Installing the Cable Tie-Wrap Kit
Installing the Module
Installing the Cable Tie-Wrap Kit
A cable tie-wrap kit is included with the Security Module. If you use a cable
connector other than a 180° cable connector (for example, a 90° cable
connector), you must secure the cable to the module connector using the
tie-wrap kit. 3Com recommends using a 180° cable connector with the
Security Module.
If you are using a 180° cable connector with the Security Module, skip this
procedure and proceed to the next section, Installing the Module.
Note: Perform the tie-wrap kit installation procedure prior to
installing the module into a 3Com ONline System
Concentrator.
The tie-wrap kit contains:
Kit card containing kit part number
1 Phillips-head screw
1 Tie-wrap bracket
3 Tie-wraps