Filter
Top Products
TELNET Commands A-21
update software tftp
<filename>
server <ip_addr>
path <path>
VERIFY
verify filter
<filter_name>
Verifies the syntax of a filter file, which has been previously added to the table. If
you update a filter file and TFTP it to the FLASH file system, and the file already
exists in the filter table, then you use this command to verify the files syntax. You
can use list filters to see which files are currently in the filter file table, and what
the status of each is.
TELNET
Commands
The following commands are available to TELNET users. They are accessed by
pressing control - ].
close Closes the active TELNET connection.
help Lists the available commands
send <string> Transmits a TELNET control character. Be sure the parameters are uppercase. The
choices are:
set_escape <string> Allows changing the TELNET escape character from ^] to something else. Control
characters are specified using the carat character followed by another character.
For example, to set the TELNET escape character to control - X, type set_escape
^X.
status Displays the IP address of the remote host and the value of the TELNET escape
character.
CLI Exit
Commands
These commands are available to TELNET users so they can disconnect from the
CLI.
Bye, Exit, Leave, Quit Leave the CLI, but keep this connection open. This command returns you to the
TELNET commands.
Parameters Description
AYT Are you there
IP Interrupt process
BRK Break
AO abort output
EC erase character
EL erase line
GA go ahead
NOP no - operation
EOR end of record
SYNC synch