Filter
Top Products
41
GRAND TOTAL PRESET
The Grand Total is located at the bottom of your "Z" Report. The Grand Total is the only figure that does not reset
back to zero after taking a "Z" Report. It is commonly known as the "running grand total". However, if you wish,
you can reset the Grand Total to zero or assign it a specific value. The procedure used to assign a value to the
Grand Total may be helpful after a Full System Clear is performed; since it automatically resets the Grand Total
back to zero.
TO SET THE GRAND TOTAL TO ZERO
The Grand Total can be a maximum of 12 digits. When clearing the Grand Total, it is recommended to follow
these steps to reset the total to zero.
"PRG" + (777777) + [AMOUNT TEND/TOTAL] + (0) + [NON TAX]
NOTE: It is recommended to take a "Z" reading prior to setting the Grand Total to zero.
1. Turn the key to the "PRG" (PROGRAM) position.
2. If a Manager Password has been programmed, ENTER the (PASSWORD #), then PRESS the [CLERK]
key, or if you did not program a Manager Password, go to Step 3.
3. ENTER (777777), PRESS the [AMOUNT TEND/TOTAL] key, ENTER (0), then PRESS the [NON TAX]
key.
TO ASSIGN A VALUE TO THE GRAND TOTAL
"PRG" + (777777) + [AMOUNT TEND/TOTAL] + (Assigned Value) + [NON TAX]
12 digits (maximum)
Example: Set the Grand Total for $15,000.00:
1. Turn the key to the "PRG" (PROGRAM) position.
2. If a Manager Password has been programmed, ENTER the (PASSWORD #), then PRESS the [CLERK]
key, or if you did not program a Manager Password, go to Step 3.
3. ENTER (777777) then PRESS the [AMOUNT TEND/TOTAL] key.
4. ENTER (1500000) then PRESS the [NON TAX] key.
abcoffice
www.abcoffice.com 1-800-658-8788