Filter
Top Products
2 DAC960PG DAC960PJ Quick Installation Guide
Connectors and Jumpers
Up to three Ultra SCSI channels are supported on the controller. The SCSI
connector locations are shown in Figure 1.
All the jumpers should normally be set to their default settings. See Table 1
for default jumper settings. Jumper locations are shown in Figure 1.
Figure 1. DAC960PG/PJ with Component Locations
Table 1. Jumper and Connector Descriptions
Jumper Description Default Setting
JP4 Header for optional front panel LED –
JP5 Serial Port Connector –
JP6 maintenance – do not use Installed
J5 Intelligent Battery Backup connector – If an IBBU is
not installed, a loopback plug must be installed in this
socket.
Installed at
factory