Filter
Top Products
37
Configuring the hot-swappable cage
This section includes instructions for removing and installing the
hot-swappable cage as well as procedures on how to install a hard disk
into the cage’s hard disk carrier.
Note: The hot-swap SCSI HDD Cages can not be cascaded for
Altos G701 model.
Removing the hot-swappable cage
Important: Before detaching the hot-swappable cage from the
chassis, make sure to first remove all hard disks from their carriers.
For instructions, refer to the succeeding section.
1 Detach the chassis panels and remove the air baffle.
2 Loosen the four thumbscrews that secure the cage to the chassis
(1).
3 Slightly pull out the cage from the chassis (2).
4 Disconnect the following cables from the cage:
aSCSI cable
AA G701 - EN.book Page 37 Tuesday, February 25, 2003 5:19 PM