Filter
Top Products
3 Upgrading your system42
To remove the hard disk drive under the floppy disk drive:
a Disconnect the diskette drive (1), hard disk (2) and power
cable (3) connected to the floppy drive and hard disk.
Note: To remove the floppy drive cable, use your fingers or a flat
screw driver to gently lift the cable retainer on the connector (a)
then lift the cable up as shown inset on the figure below.
Attach the cable retainer to the connector and push it in to
connect the floppy disk drive cable (b,c).
b Remove the screw that holds the diskette drive and hard disk
assembly to the housing (4).
c Slide (5) then lift up the assembly from the system housing (6).
aa r300.book Page 42 Tuesday, March 4, 2003 9:39 AM