Filter
Top Products
91
• Are the fan power connectors properly connected to the server
board?
• Is the cable from the front panel board connected to the server
board?
• Are the power supply cables properly connected to the server
board?
• Are there any shorted wires caused by pinched cables or power
connector plugs forced into power connector sockets the wrong
way?
If the switches and connections are correct and AC power is available
at the wall outlet, contact your service representative or authorized
dealer for help.
Diskette Drive Activity Light Does Not Light
Check the following:
• Are the diskette drive power and signal cables properly installed?
• Are all relevant switches and jumpers on the diskette drive set
correctly?
• Is the diskette drive properly configured?
• Is the diskette drive activity light always on? If so, the signal cable
may be plugged in incorrectly.
• If you are using the onboard diskette controller, use the Setup
Utility to make sure that “Onboard Floppy” is set to “Enabled.” If
you are using an add-in diskette controller, make sure that
“Onboard Floppy” is set to “Disabled.”
If the problem persists, there may be a problem with the diskette drive,
server board, or drive signal cable. Contact your service representative
or authorized dealer for help.
CD-ROM Drive Activity Light Does Not Light
Check the following:
• Are the power and signal cables to the CD-ROM drive properly
installed?
• Are all relevant switches and jumpers on the drive set correctly?
• Is the drive properly configured?
BS811.f/cppl!!Qbhf!:2!!Uvftebz-!Opwfncfs!37-!3113!!21;19!BN