Filter
Top Products
661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218
© Copyright 2005 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
RMC 7182
1U Rackmount System
LAN1/2 Enable/Disable
Change the setting of jumper JPL1 and JPL2 to
enable or disable the LAN1 and LAN2 Ethernets
ports, re- spectively. See the table on the right for
jumper settings. The default setting is enabled.
Watch Dog Enable/Disable
JWD controls the Watch Dog function. Watch Dog
is a system monitor that can reboot the system
when a software application hangs. Jumping pins
1-2 will cause WD to reset the system if an applica-
tion hangs. Jumping pins 2-3 will generate a non-
maskable interrupt signal for the application that
hangs. See the table on the right for jumper set-
tings. Watch Dog must also be en- abled in BIOS.
Note: When enabled, the user needs to write their
own application software in order to disable the
Watch Dog Timer.
USB Wake-Up
Use the JPUSB1 jumper to "wake-up" your system
by pressing a key on a USB keyboard or clicking
the USB mouse. The JPUSB1 jumper is used
together with the USB Wake-Up feature in the
BIOS. Enable this jumper and the USB feature in
the BIOS to wake-up your system via USB devices.
Note: When the USB function is set to Enabled in
the BIOS, and a USB Wake-up jumper is set to
Disabled, remove the USB devices from the USB
ports whose USB jumper is Dis- abled before the
system goes into the standby mode.