Filter
Top Products
We thank you very much for purchasing the Acroprint
BOSS Battery Operated with Solid State Quartz Controlled
Accuracy) Time Recorder. Many engineering and testing
hours have been spent in producing for you an extremely
accurate State of the Art portable (Battery Powered) Time
Recording Device.
This instruction pamphlet covers the following Acroprint
BOSS Recorder:
1. BP125-6 A stand alone recorder for use with four (4) standard
D cell, 1.5 Volt DC Alkaline Batteries (batteries not
included).
2. BP125-R6 For use with four (4) standard Rechargeable 1.5
Volt DC Batteries. Equipped with built-in Trickle
BATTERY Charger. Recorder will run for several
days after power interruption. Batteries should last
for 4 to 5 years. For use in either 110 Volt or 220
Volt AC Power systems. The desired voltage should
have been specified when recorder was ordered.
3. BP-125-12 For use in Motor Vehicle with 12 Volt DC Battery or
for use in Extremely Cold Climates with a
(suggested) 12 Volt DC Lead Acid Battery (battery
not included).
GENERAL INSTRUCTIONS
For instructions covering the removal of the case cover,
setting the recorder, changing the ribbon and general
maintenance, please see the enclosed General User
Instructions Pamphlet.
The BP125-6 ACROPRINT BOSS Recorder
Your new Battery Powered Acroprint Recorder is designed
to operate on four (4) 1.5VDC D cell batteries. Any make
battery will be satisfactory; however, we recommend that
you use Alkaline Batteries, which should provide you with
several months of reliable operation.
BATTERY POWERED USER INSTRUCTIONS
ACROPRINT 125 BOSS TIME CLOCKS
INSTALLING THE BATTERIES
To install the batteries, loosen and remove the Butterfly
Nuts at the top of the Assembly Frame which will enable
you to pivot the entire clock mechanism forward on the
bottom screws; thereby, allowing you to gain access to
the battery holder mounted on the inside back of the case.
The top battery should have the positive terminal on the
left, as indicated on the battery holder. The positive terminals
on the other three (3) batteries should alternate as shown
on the battery holder.
If two of the batteries are improperly installed, a red light
on the circuit board, which is mounted in the upper right
hand corner of the back case, will glow RED. (See Figure
2.) If all is well, the recorder should advance one (1) minute
within sixty (60) seconds after the batteries have been
properly installed.
WEAK BATTERY WARNING
When the batteries have discharged voltage down to a
certain point, a beeper on the circuit board will be activated.
When you hear the beeping, we recommend replacing the
batteries within five (5) days or the recorder may begin to
lose time or stop altogether. (See Figure 2.)
FIGURE 1
Butterfly Nut
Pivot
Screw
125 Battery Powered (6V DC)