Actiontec electronic HPE400T Network Card User Manual


 
10
Actiontec MegaPlug 4-Port Hub User Manual
11
Chapter 3 Using the Configuration Utility
Local Device(s) on Your Computer
The list displays all MegaPlug Hubs connected to the computer.
☞
Note: If no Hub appears in the Device List, make sure the Hub
is connected properly (with the appropriate Ethernet cable) to
the computer. Then, unplug the Hub, and plug it back in again.
If, after performing these actions, no Hub appears in the Device
List, the Hub may be defective. Contact technical support.
Network List
The Network List (the list box at the center of the Network tab) lists all other Hubs
connected to this MegaPlug network. Only Hubs with the same password as the
Hub connected to this computer are shown on this list. The available Hubs are
listed by their MAC addresses, and include their device name, device ID, and the
quality of the connection.
Add
Clicking this button allows the user to add a MegaPlug Hub to the network. In the
window that appears, enter the device name and password in the appropriate text
boxes, then click OK.
Rename
Clicking this button allows the user to rename a MegaPlug Hub listed in the Network
List. Select the device from the Network list, click Rename, then enter the new name.
Enter Device ID
Clicking this button allows the user to enter a MegaPlug Hub device ID. The device
ID is found on the sticker attached to the Hub (see page 3).
MegaPlug Encryption Key
Enter an encryption key in this text box to provide security for your MegaPlug net-
work. A key is similar to a password, and can be made up of any combination of
letters or numbers, from 4 to 24 characters long. Once activated, this key must be
entered into a devices network configuration to join the MegaPlug network.