Filter
Top Products
Saving the Configuration and Effecting Changes
36 Megabit Modem 410F and 420F User Manual
SAVING THE CONFIGURATION AND
EFFECTING CHANGES
As you make changes to the modem configuration, click the Submit buttonontheWebpageto
accept changes and write the changes to RAM. After you make all the necessary changes, you
must save them to Non-Volatile RAM (NVRAM). The following LAN-WAN configuration
changes are not permanent until you write them to NVRAM and will not take affect until the
modem is reset:
• forbothLANandWAN:
– IP address and IP net mask (subnet IP mask) (page 49)
– RIP version (see page 50)
• when DHCP is enabled (page 50):
– DHCP start IP address (which the modem automatically sets)
– primary DNS IP address
– secondary DNS IP address
See the following sections to:
• save configuration changes to NVRAM on page 37
• reset the modem to activate the configuration on page 38
• reset the modem to restore the factory default values on page 39
When you click the
Submit button on the Web page to accept ADSL configuration changes, the
changes are automatically written to NVRAM. You must reset the ADSL link to effect these
changes.
See the following sections to:
• reset the ADSL link to activate the ADSL configuration on page 54
• reset the modem to restore the factory default values on page 39