Filter
Top Products
ADCP-96-015 • Issue 1 • July 2004
Page 8
© 2004, ADC Telecommunications, Inc.
3 MOUNTING THE CABINET ON A FIBERGLASS MOUNTING SLEEVE
The FMS-20000, shown in Figure 3, is a fiberglass and polymer concrete sleeve that may be
used to support the cabinet at ground level. The FMS may also be used as a splicing vault. Four
vertical racks are molded into the sides of the FMS to accommodate removable rungs (not
provided). The rungs provide support for splice cases or OSP cable storage.
3.1 Installation Recommendations
The site chosen for the installation must conform to all local codes and any permits required
must be obtained prior to the start of installation. The location must be accessible and provide
adequate parking for worker and vehicle safety.
The installed cabinet must not create a visual or physical obstruction to vehicular or pedestrian
traffic. Ensure that there is sufficient space on all sides to facilitate cabinet installation.
Depending on the landscaping requirements, the top surface of the mounting sleeve may be
located from 0 to 4 inches (10.2 cm) above the surrounding grade.
Figure 3. Fiberglass Mounting Sleeve (FMS-20000)
29.81 IN.
38.5 IN.
30.0 IN.
47.0 IN.
68.0 IN.
FMS ADAPTER
COVER
FMS COVER
FIBERGLASS
MOUNTING
SLEEVE (FMS)
19161-B