ADC ACE-142S/142V Network Card User Manual


 
ADCP-96-015 Issue 1 July 2004
Page 41
© 2004, ADC Telecommunications, Inc.
8 PRE-INSTALLED DISTRIBUTION CABLE CONFIGURATION
ACE-142V cabinets are equipped with pre-installed distribution cables that enter/exit the
cabinet from the bottom. At the entry/exit points, each cable is secured with a clamp. Beyond
the clamp, the outer sheath of each cable is removed and the fibers are broken out into subunits.
Each subunit is fanned out into twelve individual fibers and each fiber is terminated with a
connector. The fiber subunits are routed to the connector panels where each fiber is connected to
a bulkhead adapter.
Each connector panel can accommodate six 12-fiber subunits which equals 72 fiber ports per
panel. Each distribution cable typically has a fiber count that is a multiple of 72 to correspond
with the number of ports provided by each connector panel. Depending on the option ordered,
cabinets may be equipped with up to nine distribution cables. A drawing is provided with each
ACE-142V cabinet that indicates the connector panel and optical port assignments for the fibers
within each distribution cable. Refer to this drawing when splicing to determine the terminating
port for each fiber within each cable. A diagram of a typical distribution cable configuration is
shown in Figure 33.
Figure 33. Pre-Installed Distribution Cable - Typical Configuration
BACK
19817-A
PANEL 1
FIBERS
1 -72
PANEL 3
FIBERS
1 - 72
PANEL 4
FIBERS
73 - 144
PANEL 5
FIBERS
145 - 216
PANEL 2
FIBERS
73 - 144
CABLE 2
SUBUNITS
1 - 18
(216 FIBERS)
SPLITTERS SPLITTERS
CABLE 1
SUBUNITS
1 - 12
(144 FIBERS)