Filter
Top Products
ADDONICS TECHNOLOGIES
Model: DGC3
Quick Guide
I. DigiCopier III Overview
There are four buttons and an LCD on the panel of DigiCopier III.
1 – LCD shows a function or a message.
2 – it is used to scroll up function menus.
3 – it is used to scroll down function menus.
4 – it is used to execute a function.
5 – it is used to cancel a function.
II. Connecting the power cable and turning on the
DigiCopier III
a. Connect the power cord provided from the wall outlet to the
back of the DigiCopier III.
b. A main power switch is located at the back of the tower. Turn
the switch on. Another auxiliary power switch is located on
the front of the tower.
III. Steps for the Copying Process
Note: may not able to copy-protected DVD or CD.
Step 1 Turn on the DigiCopier III by
pressing the auxiliary power switch.
Step 2 Insert media you wish to duplicate
into the source tray on the top.
Step 3 Populate the destination trays with
blank CDs or DVD media. A rewritable DVD
containing old data can also be use, but the
old data will be automatically erased.
Step 4 After the DVD-ROM and DVD
writers detect DVDs, press ENT button to
start copying.
LCD will show the copying information as follows.
When copying is in progress, MB and time will decrease while
the percentage of completion will increase. “MB” means the size
of data that you want to copy.
When copying comes to an end, LCD will show the results as
follows. The DVDs that were successfully copied will eject
automatically.
The complete user manual of the DVD Duplicator can found in
the Driver Disk under User Guides or can be downloaded from
http://www.addonics.com/support/user_guides/
TECHNICAL SUPPORT
Email: http://www.addonics.com/sales/query/
Internet: http://www.addonics.com
Technical Support (8:30 am to 6:00 pm PST)
Phone: 408 453-6212
Email: http://www.addonics.com/support/query/
Auxiliary
Power Switch
Source tray
Destination tray 1
Destination tray 2
Destination tray 3
LCD Panel