ADTRAN 1200214L1 Network Card User Manual


 
61200214L1-1 IQ Probe User Manual 27
Chapter 4. Applications
Gateway IP Address (if required)
Enter the Gateway node IP address. This address is applicable
only if the IQ Probe and the network manager are connected
through a Gateway node. This address is available from the
network administrator.
The next five settings are applicable for SNMP access only:
Read Community
Set the Read Community name to match the NMS (network
management system) settings.
Write Community
Set the Write Community name to match the NMS settings.
Trap Manager DLCI
Identify the virtual circuit used for all traps generated by the IQ
Probe. This selection is found under TRAP MGR OPTIONS in
the SYSTEM portion of the CONFIGURATION menu.
Trap Manager IP Address
Enter the IP address of the SNMP manager to which the IQ
Probe sends traps. This selection is found under TRAP MGR
OPTIONS in the SYSTEM portion of the CONFIGURATION
menu.
Trap Manager Port
Enter the IQ Probe port used to transmit traps to the SNMP
manager. This selection is found under TRAP MGR OPTIONS in
the SYSTEM portion of the CONFIGURATION menu.
You may assign up to five possible trap destinations in the TRAP MGR
OPTIONS table.
In-Band Management
The ADTRAN IQ Probe supports three modes of in-band
management using the frame relay structure of PVCs. These
modes are local (see Figure 4-3), shared (see Figure 4-4), and
dedicated PVC management (see Figure 4-5). All three types
support complete SNMP management as well as TELNET
capabilities.