ADTRAN 1224 Switch User Manual


 
Quick Start Guide, 61200500L1-13F, September 2005 Technical Support 1-888-4ADTRAN (1-888-423-8726) Copyright © 2005 ADTRAN, All Rights Reserved
For more detailed documentation, visit us online at www.adtran.com.
Quick Start Guide
®
NetVanta 1224 Series Switches
P/N 1200500L1/1200504L1/1200510L1/
1200520L1/1200590L1
NETVANTA 1224 FRONT PANEL LAYOUT
NETVANTA 1224STR FRONT PANEL LAYOUT
NETVANTA 1224ST FRONT PANEL LAYOUT
NETVANTA 1224 AND 1224ST REAR PANEL LAYOUT
NETVANTA 1224R AND 1224STR (AC VERSION) REAR PANEL LAYOUT
GETTING STARTED
Two configuration methods are available for your NetVanta switch:
Web-based GUI
AOS Command Line Interface (CLI)
The GUI lets you configure the main unit settings and provides online guidance and explanations
for each setting. However, using the AOS CLI may be necessary for more advanced
configurations.
ACCESS THE GUI
You may access the web-based GUI from any web browser on your network by following these
steps:
1. Connect the switch to your PC using any of the 24 Ethernet ports on the front of the unit.
2. Set your PC to a fixed IP address of 10.10.10.2. If you cannot change the PC’s IP address,
you will need to change the unit’s IP address using the CLI. (Refer to the next two sections
for instructions.)
3. Enter the unit’s IP address in your browser address line. The default IP address is
10.10.10.1.
4. You will then be prompted for the username and password (the default settings are admin
and password).
5. The initial GUI screen appears.
ACCESS THE CLI
Access the AOS CLI via the CONSOLE port or a Telnet session. To establish a connection to the
NetVanta switch CONSOLE port, you need the following items:
VT100 terminal or PC (with VT100 terminal emulation software)
Straight-through serial cable with a DB-9 (male) connector on one end and the appropriate
interface for your terminal or PC communication port on the other end
1. Connect the DB-9 (male) connector of your serial cable to the CONSOLE port on the rear
panel of the unit.
2. Connect the other end of the serial cable to the terminal or PC.
3. Provide power to the unit as appropriate. Refer to the NetVanta 1000 and NetVanta 1000R
Series Hardware Installation Guide (provided on the ADTRAN OS System Documentation
CD) for more details.
4. Once the unit is powered up, open a VT100 terminal session using the following settings:
9600 baud, 8 data bits, no parity bits, and 1 stop bit. Press <Enter> to activate the AOS CLI.
5. Enter enable at the > prompt.
6. Enter the enable password when prompted. The default password is password.
The configuration parameters used in the examples outlined in this
document are for instructional purposes only. Please replace all
underlined entries (
example) with your specific parameters to configure
your application.
NETVANTA 1224R FRONT PANEL LAYOUT
NETVANTA 1224STR (DC VERSION) REAR PANEL LAYOUT
-48V....., 1.2A
+24V....., 2.5A
USE COPPER
CONDUCTORS ONLY