Filter
Top Products
8 Installation and User’s Guide
Fuses and breakers
Before cleaning the system
Overcurrent protection
Statement of Compliance and Declaration of Conformity
This product has been designed and tested in accordance with accepted
industry standards, and has been supplied in a safe condition. The
documentation contains information and warnings that must be followed
by the user to ensure safe operation and to maintain the product in a safe
condition.
The Manufacturer’s Declaration of Conformity is available upon request.
Statement of CAN/CSA Compliance
This product has been designed and tested in accordance with
CAN/CSA- C22.2 No. 61010- 1 IEC.
CAUTION
The front panel LINE switch disconnects the mains circuit from the
mains supply. However, the mains supply to the power distribution unit
remains energized.
WARNING
For continued protection against fire hazard, use only fuses with the
required rated current, voltage, and specified type (normal blow,
time delay). Do not use repaired fuses or short-circuited fuse
holders. Replace only with an identical fuse.
There are two resettable thermal breakers located on the power
strips. These are in the “hot” and “neutral” lines.
WARNING
To prevent electrical shock, disconnect the system from mains before
cleaning. Use a dry (or slightly water-dampened) cloth to clean
external case parts. Do not attempt to clean internally.
CAUTION
If the power outlet strip breaker trips once, reset the breaker. If the
breaker trips twice, call a qualified/licensed electrician to service the
test system.