Agilent Technologies 85225F Network Card User Manual


 
86 Installation and User’s Guide
2 Installing the System
6 Connect the bias
networks to the device
under test.
a Connect one semi-rigid cable to the RF/DC
OUT connector of the port 1 bias network.
b Connect the other semi-rigid cable to the
RF/DC OUT connector of the port 2 bias
network.
c Connect the device under test to the
semi-rigid cable attached to the port 1 bias
network.
d Connect the device under test to the
semi-rigid cable attached to the port 2 bias
network.
The semi-rigid cables part number is
85107-20004.
* Refer to Figure 4, “Front Panel Wiring Diagram with Agilent E5260A or E5270B,” on page 27.
To connect the bias networks (continued)
Step Action Notes