Filter
Top Products
85330A Multiple Channel Controller A-1
Glossary
A Glossary
a1
The reference IF channel of the 8530A. This channel can be used as a phase
lock reference or a test channel.
a2
The test IF channel of the 8530A. This channel can be used as a phase lock
reference or a test channel.
AUT
Antenna Under Test
b1
One of three test channels of the 8530A.
b2
One of three test channels of the 8530A.
Channel
Each switch module has either two or four possible switch positions, or
channels.
Controller
The mode the 85330 operates in when it is controlling other 85330As. Refer
to “RUNTime:CONTroller” command on page 7-8 and Chapter 6,
“Programming” for more information.
Direct Control
Direct control is where the host computer issues GPIB commands and the
85330A executes them immediately. For example, the
ROUTe:CLOSe (port
number) (switch address)
command causes the 85330A to immediately change
switch states. Use of such commands is referred to as direct control.
Fast CW Modes
Refer to the glossary entry for “Fast Data Acquisition Modes.”