Agilent Technologies 85330A Network Card User Manual


 
85330A Multiple Channel Controller vii
Safety Earth
Ground
This is a Safety Class I product (provided with a protective earthing
terminal). An uninterruptible safety earth ground must be provided from the
main power source to the product input wiring terminals, power cord, or
supplied power cord set. Whenever it is likely that the protection has been
impaired, the product must be made inoperative and secured against any
unintended operation.
Before Applying Power Verify that the product is configured to match the available main power
source as described in the input power configuration instructions in this
manual. If this product is to be powered by autotransformer, make sure the
common terminal is connected to the neutral (grounded) side of the ac power
supply.
WARNING No operator serviceable parts inside. Refer servicing to qualified personnel. To
prevent electrical shock do not remove covers.
WARNING For continued protection against fire hazard, replace line fuse only with the
same type and ratings (type nA/nV). The use of other fuses or materials is
prohibited.
WARNING To prevent electrical shock, disconnect the 85330A from mains before
cleaning. Use a dry cloth or one slightly dampened with water to clean the
external case parts. Do not attempt to clean internally.
The CE mark is a registered trademark of the European
Community. (If accompanied by a year, it is when the design
was proven.)
The CSA mark is a registered trademark of the Canadian
Standards Association.
This is a symbol of an Industrial Scientific and Medical
Group 1 Class A product.
ICES /
NMB-001
This is a marking to indicate product compliance with the
Canadian Interference-Causing Equipment Standard
(ICES-001).
The C-Tick mark is a registered trademark of the
Australian Spectrum Management Agency.