Filter
Top Products
1-6 Agilent 87130A Operating and Service Manual
Introducing the 87130A Attenuator/Switch Driver
Unpacking Your Instrument
Unpacking Your Instrument
Unpack and inspect the shipping container and its contents thoroughly to
ensure that nothing was damaged during shipment. If the shipping container
or cushioning material is damaged, the contents should be checked both
mechanically and electrically.
WARNING To avoid hazardous electrical shock, do not perform electrical tests when there
are signs of shipping damage to any portion of the outer enclosure (covers,
panels, connectors.)
Table 1-3 87130A Package Contents
❍ If the shipping container is damaged, or the cushioning material
shows signs of stress, notify the carrier as well as Agilent
Technologies. Keep the shipping material for the carrier’s
inspection. Refer to Figure 1-3.
❍ If the contents are damaged or defective, contact your nearest
Service Center listed under “Service and Support” on page v.
Agilent will arrange for repair or replacement of the damaged or
defective equipment. Always refer to your instrument by its full
model number and serial number.
Determining Your
Module Serial Number
A serial number is attached to a label on the rear panel of the module. The
first six entries are the same for all identical modules; they only change
when a change in the electrical or physical functionality is made. The
remaining entries change sequentially and are different for each module.
Environmental
Limitations
The instrument should be stored in a clean, dry environment. The following
environmental limitations apply to both shipment and storage:
Temperature
− 40 to + 70° C
Humidity < 95% relative
Altitude < 15300 meters (50,000 feet)
Description Quantity Part Number
Switch driver 1 87130A
Operating and Service Manual 1 87130-90007
Cable, 68-pin to 68-pin SCSI II, 6 ft. 1 70611-60004