Agilent Technologies 8722ET Network Card User Manual


 
1-12 Chapter1
Installing Your Analyzer
STEP 4. Configure the Analyzer
3. Press and then choose either or
, depending on your printer/plotter device. Or, if you are plotting
your files to disk, press .
4. Press the key that corresponds to your printer or plotter interface: ,
(parallel port), or (serial port).
NOTE The plotter menu is shown as an example. It will only appear if you select
. Similar interface choices will appear if you select
.
If you select , the GPIB address
selection is active. Enter the GPIB
address of your printer or plotter,
followed by .
If you have already selected the
choice for the
parallel-port configuration, you must
also select in this menu in
order to generate a hardcopy.
SET ADDRESSES
PRINTER PORT
PLOTTER PORT
SET ADDRESSES
PLOTTER PORT
DISK
GPIB
PARALLEL
SERIAL
PLOTTER PORT
PRINTER PORT
GPIB
x1
PARALLEL [COPY]
PARALLEL