Filter
Top Products
Chapter 1 1-17
Installing Your Analyzer
STEP 4. Configure the Analyzer
To Attach Front Handles to the Analyzer (Standard)
1. Ensure that the front handle kit is complete. 2. Remove the side trim strips.
• (2) front handles
• (6) screws
• (2) trim strips
NOTE If any items are damaged or
missing from the kit, contact the
nearest Agilent Technologies
sales or service office to order a
replacement kit. Items within
the kit (handles, flanges, screws,
etc.) are not individually
available.
3. Attach the handles to the sides of the front
panel, using three screws for each handle.
4. Place the new trim strip over the screws on
the handles.
WARNING If an instrument handle is
damaged, you should replace
it immediately. Damaged
handles can break while you
are moving or lifting the
instrument and cause
personal injury or damage to
the instrument.