Filter
Top Products
1-24 Chapter1
Installing Your Analyzer
STEP 5. Verify the Analyzer Operation
To Test the Transmission Mode
1. Connect the equipment as shown and press
.
2. To check the forward transmission mode for
channel 2, press
or
.
NOTE The test port return cable
should have low-loss
characteristics to avoid a
degradation in frequency
response at higher frequencies.
3. Look at the measurement trace displayed
on the analyzer. It should be similar to the
trace below.
4. ES models only: To check the reverse
transmission mode for channel 2, press
.
The measurement trace should be similar
to the trace below.
Preset Chan 2 Meas
Trans: FWD S21(B/R)
TRANSMISSN
Meas
Trans: REV S12 (A/R)