Filter
Top Products
Set Up Your System 3
Agilent E6474A User’s Guide 33
Verifying installation using the Configuration Utility
To verify the driver installation:
Figure 7 Configuration Utility
Test the ports using the Test Ports button:
Do this
Notes
1 Connect and switch on the E6473B hub.
2 Select Start > Programs > Agilent Technologies >
Configuration Utility.
3 Select the General tab.
4 Expand the device tree so that you can see all six ports. Refer to Figure 7.
NOTE
This test uses an internal loopback to test the ports. Devices that generate
data without being polled (for example a GPS receiver or certain phones)
can cause this test to fail. You must unplug all devices before testing the
ports.