Filter
Top Products
Use Your System 4
Agilent E6474A User’s Guide 81
Identifying devices
The software must identify the attached devices before it can
communicate with them. Devices include phones, Agilent digital
receivers, and the navigator (if equipped). This process is also
referred to as “configuring the system.”
More information on identifying devices and system
configuration can be found in the online help and quick basics.
Refer to “Get results fast" on page 93.
NOTE
Generic data devices are configured differently than phones used in
conversation mode. See “Generic data devices" on page 88 for setup
information.
NOTE
If you are using the E6473B hub and are uncertain about which COM ports
are assigned and need assistance in determining which COM port is
assigned to each specific device, refer to “Verifying E6473B hub
installation" on page 32.