Filter
Top Products
Use Your System 4
Agilent E6474A User’s Guide 91
Figure 45 Data device added
Configuring data device properties
To perform throughput and timing calculations, you should use
Agilent Data Server Software. For more information on this
software and how it works, refer to the Agilent Data Server
software installation guide (E7475-90012).
Before you can perform a test with the data server, you must
configure the properties of the data device added to the data
port. The properties dialog box for the data device allows you to
configure the test conditions and parameters. See “Configuring
devices and views" on page 84 for instructions on opening this
dialog box.
NOTE
Although the Agilent E6474A software shows the COM port in the System
Setup view that the data device is connected to, that COM port cannot be
used for configuring the device’s properties. Data Device properties can
only be configured by right-clicking on the Data Device, then choosing
Properties from the pop-up menu.