Agilent Technologies N2610A Network Card User Manual


 
120 Agilent FrameScope 350 User’s Manual
5 Cable Testing in Expert Mode
The Expert Autotest Setup
3 In the Profile Setup screen, press the desired profile. If the scroll bar
is not full length, use the scroll rocker to scroll down to see more
stored profiles
4 Press OK when done.
5 Press Start Test to run the Autotest.
Editing an Existing Settings Profile to Remove a Lock
You may also edit or delete existing profiles, including the
Default profiles. It is recommended that you do not edit nor
delete the Default profiles, as you must reload the software to
get them back in their original form to meet the standards. To
create a profile similar to a default profile, first select the
desired default profile to set the locked settings. Then create a
new profile as described in the next section.
To edit an existing settings profile:
1 In Expert Mode, press Autotest. On the Autotest Settings screen,
press Edit Settings, then press Profile, then press Edit.
1 On the Profile Setup Screen, press the selected profile, then press
Update Selected, then press Next.
2 Change the lock settings by pressing the appropriate boxes. The
check marks toggle with subsequent presses. Then press Next. If the
Test Probe setting is locked, you will see the center screen below,
which will prompt you to select the Performance Grade of the probe
as well as the Probe Test Count Limit, if desired. Then press Next. If