Filter
Top Products
122 Agilent FrameScope 350 User’s Manual
5 Cable Testing in Expert Mode
The Expert Autotest Setup
350 use the existing settings for all the parameters. See the remainder
of this section to configure the other settings.
2 In Expert Mode, press Autotest. On the Autotest Settings screen,
press Edit Settings, then press Profile, then press Edit.
3 On the Profile Setup Screen, press Create New Profile, then press
Next. Press anywhere in the Profile Name area to open a keyboard to
allow you to enter the new profile name. After entering the new
name, press OK, then press Next.
4 Change the lock settings by pressing the appropriate boxes. The
check marks toggle with subsequent presses. Then press Next. If the
Test Probe setting is locked, you will see the center screen below,
which will prompt you to select the Performance Grade of the probe
as well as the Probe Test Count Limit, if desired. Then press Next. If
the Test Probe setting is not locked you will go directly to the