Filter
Top Products
222 Agilent FrameScope 350 User’s Manual
10 DualRemote 350 Reference
The DualRemote 350
Pass/Fail: The Pass/Fail indicator turns green when the test passes, or
red when the test fails.
Diagnostics
The Diagnostics section of the DualRemote 350 front panel provides
more detailed information about failing test results.
WS and DR: Indicate at which end of the tested cable the measurement
failed.
• WS lights when a failure occurs at the FrameScope end of the
circuit.
• DR lights when a failure occurs at the DualRemote end of the
circuit.
• WS and DR both light when failures occur at both ends of the
circuit. To determine which failures occurred at which end of the
circuit, use the Scroll button.
A column of diagnostic indicators shows details about the cause(s) of a
test failure. The failures indicated on the DualRemote 350 are:
Wiremap: Turns red when a fault with the cable connections is
detected.
Split Pairs: Turns red when a split pair is detected.
Length/Delay/Skew: Turns red when cable length, signal delay, or
skew are outside the passing limits.
NEXT : Turns red when near end pair-to-pair or power sum crosstalk
faults are detected.
Attenuation: Turns red when attenuation is outside passing limits.
ELFEXT : Turns red when far-end pair-to-pair or power sum crosstalk
faults are detected.
Return Loss: Turns red when the return signal loss exceeds passing
limits.
Other: turns red when any other failing test results occur. If the cable
run has multiple test failure causes, the Scroll button scrolls between
diagnostic indications. The current selection blinks. The pair indicators
and WS or DR indicators associated with the selected failure also blink.
Power
The Power indicator turns green when the DualRemote 350 is powered
on.