Aiphone GT-HID Network Router User Manual


  Open as PDF
of 2
 
- INSTRUCTIONS -
The GT-HID is an Access Control module for the GT Entrance Panel that contains an HID ProxPoint® Plus Card
Reader. This module installs into the entrance panel and cosmetically matches, so a separate card reader does not
need to be installed. The card reader provides electronic access to a building through the standard Access Control
system, which is not supplied by Aiphone.
HID Proximity Card Reader Module for GT Entrance Panel
Page 1
INSTALLATION:
1. Install GT-HID card reader module in the GT entrance panel. (Install in a lower position for ease of access).
2. GT-HID will snap into the GF-2F or GF-3F frame.
3. Secure wire connections as shown on wiring chart.
4. Cut any unused wire so that bare wires are not exposed.
5. Refer to standard GT Installation Manual for complete system information. No additional information pertaining to
the Access Control system is provided by Aiphone.
GT-HID
(front view)
GT-HID
(back view)
To Host
18" pigtail cable
LED indicator
Connecting the Reader to the Host:
Connect the reader to the host according to the
wiring table below and the host installation guide.
Wiegand Wire Color
+ DC Red
Ground Black
--- Violet
Data0 Green
Data1 White
Shield Ground Drain
Green LED Orange
Red LED Brown
Beeper Yellow
Hold Blue