Filter
Top Products
Ver. 1A
Quick Installation Guide
1
Model # AKVM-2
Section 1
The AKVM-2 switch is a 2-port PS/2 type KVM switch
that comes with two sets of built-in 1.5M cables to save
you cabling troubles. It enables users to access, control,
boot, and reboot two computers using only one
keyboard, video monitor, and mouse. Its one-piece de-
sign offers more portability and convenience to users
than conventional KVM switches.
Introduction
Section 2
Before connecting any cable, please make sure all of your
computers and their peripherals have been powered off.
Otherwise, the KVM switch may not be set up properly.
Installation
Step 1 Make sure all the computers that are to be
connected to the KVM switch and their peripherals
are powered-off. If not, power them off before
you proceed with the following steps.
Step 2
Connect the shared keyboard, monitor, and
mouse to the main KVM unit. See Fig. 1.1
Fig 1.
1
Step 3 Connect each set of the built-in KVM cables
to a computer’s keyboard, video, and mouse ports.
You can use individual standard keyboard, mouse
and video cables to extend the cable distance, but
depending on the type of cables you use, the
maximum cable distance is limited to 5 ~ 7 meters
(15.5 ~ 23 feet).
Step 4 Power up the connected computers one by
one. After the computers are powered up, the
keyboard and mouse will be recognized and you
can begin operating the KVM switch.
Section 3
Operation
s
There are two methods to select a specific computer:
Using the push button or the hotkey sequence.
Hotkey Sequence
The hotkey sequence consists of three specific
keystrokes pressd on the keyboard.
Hotkey sequence = ScrLk + ScrLk + Command key
The two consecutive ScrLk key should be pressed
within 2 seconds and the following command key(s)
should also be pressed within 2 seconds. Otherwise,
the hotkey sequence will not be validated.
For detailed Hotkey sequences and their correspond-
ing functions, please refer to the Quick Reference
Chart on back.
Push Button
The push button lets you directly switch between the
computers. Simply press the button on the KVM unit
to select the computer.
Section 4
Technical Suppor
t
Email: support@airlinkplus.com
Website: www.airlinkplus.com
Continue on Back