Filter
Top Products
Configuring MAC Address Table Aging Time Managing Source Learning
page 2-8 OmniSwitch 6600 Family Network Configuration Guide April 2006
Note. The MAC address table aging time is also used as the timeout value for the Address Resolution
Protocol (ARP) table. This timeout value determines how long the switch retains dynamically learned
ARP table entries. See Chapter 14, “Configuring IP,” for more information.
To set the aging time back to the default value, use the no form of the mac-address-table aging-time
command. For example, the following sets the aging time for VLAN 255 (for all VLANs if VLAN ID is
not specified) back to the default of 300 seconds:
-> no mac-address-table aging-time vlan 255
To display the aging time value for one or all VLANs, use the show mac-address-table aging-time
command. For more information about this command, see the OmniSwitch CLI Reference Guide.