Filter
Top Products
OmniSwitch 6600 Series Chassis and Hardware Components Removing Uplink and Stacking Modules
OmniSwitch 6600 Series Hardware Users Guide April 2004 page 2-31
Removing Uplink and Stacking Modules
To remove an uplink or stacking module from the chassis, follow the steps below:
Anti-Static Warning. Before handling any components, free yourself of static by wearing a grounding
strap, or by grounding yourself properly. Static discharge can damage the switch and the uplink or stack-
ing module.
1 Loosen the two captive screws, located at the left and right sides of the module’s front panel. If neces-
sary, use a Phillips screwdriver to loosen the screws.
Note. Be sure that both captive screws are completely disengaged from the threaded holes in the chassis
before continuing.
Loosening the Captive Screws
EXPANSION/STACKING
5
15
2
LINK/ACT
LINK/ACT