Filter
Top Products
Features in 276-04 21
Version 276-05
C613-10474-00 REV D
CR00012287
IPv6 3 If a user set the preferred or valid timers for IPv6 router advertisements to infinite
(using the command set ipv6 interface), the resulting advertisement packets
did not have a value of infinite.
This issue has been resolved.
Y -YYY--- - -
CR00012708
many 3 The command show debug active displays information about currently-active
debugging for many modules at once. Similarly, the command disable debug
active disables debugging for many modules in a single step.
This Software Version extends the list of modules that these commands act on.
They now apply to all modules with debug support, except for DS3, ACC, Q931,
SA, SYN, TPAD, and X25C.
Y - YYYYY- - -
CR00012786
IP Gateway 3 When a link that had RIP configured on it went down, so that the router or switch
used an alternative route, output from the command show ip route sometimes
displayed incorrect information when the link came back up. When the link first
comes back up, the route's RIP metric is still 16, so the alternative route is still the
“best” route to the target. However, show ip route sometimes displayed a
disabled route over the original link, with a RIP metric of 16, as the best route,
even though the router or switch correctly used the alternative route.
This issue has been resolved.
Y - YYYYY- - -
CR00012856
Switch 3 When a port had no learn limit, adding a switch filter entry with the learn
parameter specified (using the command add switch filter action=forward
dest=macaddress port=x learn) turned on port security with a learn limit of 1.
This stopped the port from learning new MAC addresses, except through more
filter entries.
This issue has been resolved. Adding a filter with the learn parameter specified
no longer turns on port security.
- --YYYY- - -
CR Module Level Description
AR44xS/ AR450S
AR7x5
AR750S
Rapier i
AT-8800
AT-8600
AT-8700XL
AT-8948
AT-9900
AT-9800