Allied Telesis AR44xS series Switch User Manual


 
Features in 276-04 25
Version 276-05
C613-10474-00 REV D
CR00011311
IPsec 4 In output of the commands show ipsec policy and show ipsec policy
sabundle, the value for the number of bytes currently used by each SA bundle
was sometimes truncated.
This issue has been resolved, and both commands now display the correct
number. As part of this, output of the command show ipsec policy has been
modified so that the expiry limits in bytes and in seconds display on separate
lines.
Also, if the expirykbytes parameter of the command create or set ipsec
bundlespecification was given a value higher than 4193280, the router or
switch instead used a lower value.
This issue has been resolved. If you specify a value above 4193280, the router or
switch now displays a warning message and sets the expiry limit to 4193280
kbytes.
Y -YYY--- - -
CR00012270
Remote Telnet 4 The “?” help description for the enable command stated that the parameter
rtelnet would “Disable the use of remote telnet to control an asyn port”.
This issue has been resolved. The query now states that the command enable
rtelnet enables remote telnet.
Y -YY---- - -
CR00012755
Install,
Stacking
4 If the local command show config dynamic was entered as a host-directed
command, the switch gave an incorrect error message.
This issue has been resolved. If you attempt to direct show config dynamic to
a host, the switch now responds with the message “Command is local, do not
use host direction”.
- --YYYY- - -
CR Module Level Description
AR44xS/ AR450S
AR7x5
AR750S
Rapier i
AT-8800
AT-8600
AT-8700XL
AT-8948
AT-9900
AT-9800