Allied Telesis AR44xS series Switch User Manual


 
Features in 276-02 33
Version 276-05
C613-10474-00 REV D
CR00010886
IPv6,
IP Gateway,
PPP
2 When a user enabled a Dial-on-Demand PPP interface, sometimes the router or
switch did not apply the associated IP route change. This meant that routes via
the Dial-on-Demand PPP interface were not available for use. When this
occurred, routed traffic failed to activate the associated Dial-on-Demand PPP
interface.
This issue has been resolved.
YYYYY- - YYY
CR00011060
IP Gateway,
PIM
2 In networks with redundancies handled by protocols such as STP and trunking,
upstream PIM neighbours may move from one port to another. When this
happened, PIM-DM failed to re-establish multicast routes with all of its
downstream interfaces listed properly. This caused the switch to eventually stop
sending multicasts for that group via that route.
This issue has been resolved.
---YY--YYY
CR00011128
BGP 2 When running a BGP network using route reflectors, changing the cluster ID on
a router or switch could cause a restart of some of the BGP clients.
This issue has been resolved.
YYYYY- - YYY
CR00011304
VRRP 2 VRRP did not function correctly when the switch was configured with protected
VLANs.
This issue has been resolved.
---YYYY- - -
CR00011305
IPv6,
Utility
2 RIPng (RIPv6) occasionally advertised sub-optimal routes to its neighbour when
the router or switch was placed in a looped network topology.
This issue has been resolved.
YYYYY- - YYY
CR00011338
ASYN 2 If a cable carrying a continuous stream of characters is connected to a port on an
4-port ASYN PIC, the ASYN port did not always receive the characters correctly.
This was because of a port synchronisation failure to the character stream.
This issue has been resolved. The port now detects the synchronisation failure
and continues to attempt synchronisation to the character stream until
successful.
YYYY------
CR Module Level Description
AR44xS / AR450S
AR7x5
AR750S
Rapier i
AT-8800
AT-8600
AT-8700XL
AT-8948
AT-9900
AT-9800