Filter
Top Products
Features in 276-02 37
Version 276-05
C613-10474-00 REV D
CR00012013
VLAN 2 When MLD snooping was enabled and the switch received IPv6 multicast packets
(such as MLD Query, Report or Done messages; IPv6 NS packets; and IPv6 RA
packets) on a non-master port of a trunk group, it incorrectly forwarded them
out the master port. This resulted in a packet loop.
This issue has been resolved.
---YY--YYY
CR00012067
OSPF 2 A summary LSA was not turned into a route if the destination and mask fell inside
one of the router or switch’s active ranges, unless it exactly matched the active
range’s address and mask.
This complied with RFC 1583 section 16.2. However, the recommended
behaviour has been modified in RFC 2328 section 16.2. To comply with this, the
LSA is now calculated if it falls inside one of the router or switch’s active ranges.
YYYYYYYYYY
CR00012096
Core, LLDP,
Switch, Utility
2 The LLDP module and several monitoring features started up when they were not
needed. This impacted on performance.
This issue has been resolved, and therefore performance has been improved,
especially for the AR440S router.
Y---------
CR00012108
Switch 2 The command disable switch port=port-number link=disable did not
correctly disable the link for port 12 or 24 on AT-9924SP switches. It only disabled
ports 12 and 24 in software.
This issue has been resolved.
--------Y-
CR00012119
Load balancer 2 Previously, only one resstate trigger could be created for each load balancer
resource. This meant, for example, that you could create a trigger to activate a
script when a resource went down, but could not activate another script when
the resource came back up again.
This issue has been resolved. You can now define different triggers to trigger off
each of the different states available for a given resource (such as lbstate=up
and lbstate=closing).
YYYYY- - YYY
CR Module Level Description
AR44xS / AR450S
AR7x5
AR750S
Rapier i
AT-8800
AT-8600
AT-8700XL
AT-8948
AT-9900
AT-9800