Filter
Top Products
Features in 276-02 43
Version 276-05
C613-10474-00 REV D
CR00010508
BGP 3 When the router or switch received a BGP update message and created new
prefix entries for the routes in the update, it reversed the order of the AS
segments.
This issue has been resolved.
YYYYY- - YYY
CR00010952
IPv6 3 If either of the following were configured for MLD:
■ a qinterval greater than 32 seconds
■ a qrinterval greater than 128 seconds
then the router or switch sent MLDv2 query packets with incorrect Maximum
Response Code and Querier's Query Interval Code fields.
This issue has been resolved.
YYYYY- - YYY
CR00010953
IPv6 3 Previously, it was possible to enter values for the set ipv6 mld qrinterval
command that were higher than was specified in RFC 2710.
This issue has been resolved. The valid range for qrinterval is now 1 to 8387
seconds.
Note that if the router or switch acts as an MLDv1 querier and qrinterval is set
to more than 65 seconds, then the Maximum Response Code in MLDv1 query
packets will be set to 65535 milliseconds, because this is the highest valid value
for that field.
YYYYY- - YYY
CR00011105
IP Gateway 3 Configuring more than about 100 logical IP interfaces decreased the firewall
performance.
This issue has been resolved. Firewall performance is now very good even when
600 logical IP interfaces are configured.
YYY- ------
CR00011316
System 3 Previously, entering the command set summertime could cause extra digits to
appear in the output of the commands show ip interface and show config
dynam=trigger.
This issue has been resolved.
YYYYYYYYYY
CR Module Level Description
AR44xS / AR450S
AR7x5
AR750S
Rapier i
AT-8800
AT-8600
AT-8700XL
AT-8948
AT-9900
AT-9800