Filter
Top Products
Features in 276-02 44
Version 276-05
C613-10474-00 REV D
CR00011510
IPsec 3 The maximum SPI value has been increased in the commands:
create ipsec saspecification=spec-id inspi=spi
outspi=spi [other parameters]
set ipsec saspecification=spec-id inspi=spi outspi=spi
[other parameters]
The spi is now an integer in the range 256 to 4294967295.
YYYYY-----
CR00011659
TTY, VRRP 3 When VRRP debug was enabled from a telnet session, the debugging did not
stop when the telnet session closed. If the next telnet session got the same TTY
number as the closed session, VRRP debug output was displayed immediately the
session started. This made it possible for unauthorised users to view the debug
output.
This issue has been resolved.
YYYYYYYYYY
CR00011687
BOOTP 3 The command set bootp relay maxhops is now supported, in addition to the
existing command set bootp maxhops.
YYYYYYYYYY
CR00011774
Switch 3 The dot1qTpFdbPort MIB entry displays the ports on which the switch has
learned MAC addresses. Previously, the switch started the list of ports at port 0
instead of port 1.
This issue has been resolved.
---YYYYYYY
CR00011784
IP Gateway 3 If the router received an ARP response for an address outside of the receiving
interface's subnet, it discarded the ARP response. This is the intended behaviour
on some AR410 routers (see CR00010261) but not on AR7x5 routers.
This issue has been resolved. AR7x5 routers now forward such ARP responses.
-Y--------
CR Module Level Description
AR44xS / AR450S
AR7x5
AR750S
Rapier i
AT-8800
AT-8600
AT-8700XL
AT-8948
AT-9900
AT-9800