Filter
Top Products
Features in 276-01 56
Version 276-05
C613-10474-00 REV D
CR00010539
IP 2 Sometimes the forwarding of packets occurred unnecessarily slowly. This
happened if the forwarding interface was associated with an IP filter with a
variable field pattern, such as TCP session or ICMP code and type.
For switches, note that this issue occurred when the switch was routing IP packets
in software, and had no effect on the hardware forwarding of packets.
This issue has been resolved.
YY
YYYYYYYY
CR00010784
Switch 2 Previously, if a 48-port switch was configured with one or more port-specific
hardware filters, followed by one or more non port-specific hardware filters, then
the non port-specific filter was not correctly applied to half of the ports on the
switch.
This issue has been resolved by defining the following new command, which
enables you to decide which mode you want the hardware filters to operate in:
set switch hwf mode={psf|npsf}
where:
psf = port specific first (default mode)
npsf = non port-specific first
If the first filter is non port-specific, set the mode to npsf.
--
-YYYY- - -
CR00010888
Port
Authentication
2 When 802.1x port authentication was configured in multi-supplicant mode,
supplicants with EAP-TLS, PEAP-MS-CHAPv2 or PEAL-TLS authentication
methods were not able to access the network.
This issue has been resolved.
YY
YYYYYYY -
CR00010890
PPP 2 For a PPP interface over an ACC call, RADIUS accounting messages were not
being sent.
This issue has been resolved.
YY
YYY-----
CR Module Level Description
AR44xS / AR450S
AR7x5
AR750S
Rapier i
AT-8800
AT-8600
AT-8700XL
AT-8948
AT-9900
AT-9800