Filter
Top Products
Features in 276-04 7
Version 276-05
C613-10474-00 REV D
CR00011994
IPsec 1 When both Software QoS and IPSec were configured on the router or switch, it
sometimes rebooted. This happened if the IPSec SA bundle was suddenly deleted
while packets were still queued in Software QoS. For example, this issue was
more likely to occur if the expirykbytes parameter of the create ipsec
bundlespecification command was configured, and the hard expiry kilobyte
limit for an IPSec SA bundle was reached quickly.
This issue has been resolved.
Y -YY---- - -
CR00012196
IPv6 1 When RIPng deleted a route from the IPv6 route table, routing for associated IPv6
flows was not updated correctly. This caused data forwarding on those flows to
use invalid routes.
This issue has been resolved.
Y - YYY- - - - -
CR00012461
IPv6 1 Sometimes the router or switch rebooted when it received Neighbour
Advertisements that did not properly conform to RFC 2461.
This issue has been resolved. The router or switch no longer reboots if it receives
non-conformant ND packets. If debugging is enabled, the router or switch now
also displays useful information about the non-conformant packets.
Y - YYY- - - - -
CR00012571
CR00013183
IPv6 1 The router or switch sometimes rebooted when running a configuration script
that included RIPng (RIPv6).
This issue has been resolved.
Y - YYY- - - - -
CR00012614
Switch 1 When PIM6 was configured on the switch, and it received an IPv6 multicast
stream for which it had no downstream interface to forward the stream to, a
reboot could occur.
This issue was resolved in a previous software version (as CR00012097) but this
version includes an improved resolution.
Y - YYY- - - - -
CR00013025
DVMRP 1 Receiving a DVMRP Graft or Prune message occasionally caused the router or
switch to reboot.
This issue has been resolved.
Y - YYY- - - - -
CR Module Level Description
AR44xS/ AR450S
AR7x5
AR750S
Rapier i
AT-8800
AT-8600
AT-8700XL
AT-8948
AT-9900
AT-9800