Filter
Top Products
Chapter 2: Installation
32
Installing the Device
The device can be installed on a flat surface or mounted in a rack. This section includes the
following topics:
“Desktop or Shelf Installation” on page 32
“Rack Installation” on page 32
Desktop or Shelf
Installation
When installing the switch on a desktop or shelf, the rubber feet included with the device
should first be attached. Attach these cushioning feet on the bottom at each corner of the
device.
Ensure the surface is be able to support the weight of the device and the device cables.
To install the device on a surface, perform the following:
1. Attach the rubber feet on the bottom of the device. The following figure illustrates the
rubber feet installation on the device.
Figure 1: Installing Rubber Feet
2. Set device down on a flat surface, while leaving 2 inches on each side and 5 inches at
the back.
3. Ensure that the device has proper ventilation by allowing adequate space for
ventilation between the device and the objects around the device.
Rack Installation The device can be mounted in an EIA standard-sized, 19-inch rack, which can be placed in
a wiring closet with other equipment. To install the device the mounting brackets must first
be attached to the device’s sides.