Allied Telesis AT-8000GS/POE Switch User Manual


 
AT-8000GS Series Gigabit Ethernet Switch Installation Guide
41
The Startup Menu is displayed and contains the following configuration functions:
6. From the Startup Menu, press “6”.
The following prompt is displayed:
7. From the Stack Menu, press “2”.
The following prompt is displayed:
8. Enter the unit stack number. Note that Units 1 and 2 are master-enabled units. One of
them will be elected as Stack Master. Therefore, at least one unit in the stack must be
designated as either Unit 1 or Unit 2.
9. Press <Enter>. The device is defined within the stack.
10. From the Stack menu, press “3”. The Startup menu is displayed.
11. From the Startup menu, press “7”. The Startup menu is closed and the device
continues the Startup process.
Note
Once the device is booted up and operational in the stack, the
configuration can be modified through the Web or CLI.
Startup Menu
[1] Download Software
[2] Erase Flash File
[3] Password Recovery Procedure
[4] Enter Diagnostic Mode
[5] Set Terminal Baud-Rate
[6] Stack menu
[7] Back
Enter your choice or press 'ESC' to exit:
Stack menu
[1] Show box number in stack
[2] Set box number in stack
[3] Back
Enter your choice or press 'ESC' to exit:
Enter your choice or press 'ESC' to exit:
Unit number in stack: [0-6] 1