American Power Conversion AP9615 Switch User Manual


 
7
Installing the Hub
continued
Installation
procedure,
continued
3Use a
#2
Phillips head screwdriver to remove the 2
screws fastening the SmartSlot cover plate to the
back panel of the
UPS
or triple chassis. Keep the
screws for Step
5
below. Save the SmartSlot cover
plate for future use (e.g. shipping the
UPS
).
4 Orient the hub to fit into the SmartSlot. Slide the hub
all the wa
y
into the slot until its front panel is flush
with the back panel of the UPS or triple chassis.
Observe the correct orientation as shown in Figure 3.
Note that the sides of the circuit board align with the
card guides of the SmartSlot.
Note:
While it is not possible to install the hub
upside down, it is possible to damage the
unit in the attempt to do so.
Figure 3: Orient the hub to fit into the SmartSlot.
.
Continued on next page