Filter
Top Products
11
Removing the Hub
Removal
procedure
To remove the 5 Port 10Base-T Hub, perform the following
steps in the order given.
1 Disconnect all cables from the hub.
2 Turn off the UPS or device that houses the hub. (For
detailed instructions, see “Installation procedure” on
page 5.)
3Use a
#2
Phillips head screwdriver to remove the 2
screws fastening the hub to the
UPS
or triple chassis.
Keep the screws for Step 6 below.
4 Carefully grasp the sides of the hub’s front panel and
gently pull the hub from the SmartSlot.
Handle the 5 Port 10Base-T Hub by the front
panel. Do not touch the exposed printed cir-
cuit board or components. Touching the
circuit board or components may result in
damage to the hub.
5 Place the hub into its original packaging or other
static-safe material.
6 Replace the SmartSlot coverplate (removed during
installation of the hub) with the screws removed in
Step 3.