Filter
Top Products
5
Installing the Hub
Warning
Do not operate the 5 Port 10Base-T Hub where conditions
are outside the limits listed in “Product Specifications” on
page 14.
Installing on
critical systems
The installation procedure that follows may involve shut-
ting off power from the
UPS
. However, if your setup
requires maintaining power to connected equipment
throughout installation, visit the support page on our Web-
site
(http://www.apcc.com/support/#kbase)
and follow the
appropriate procedure in
Installation Instructions for
APC
Management Accessories on Critical Systems.
Installation
procedure
To install the 5 Port 10Base-T Hub, perform the following
steps in the order given.
Note: The Smart-
UPS
, Matrix-
UPS
, Symetra Power Array,
Smart-UPS DP, and Triple Chassis for Silcon require
different procedures to turn off the UPS or device that
will host the hub.
1 To turn off the
UPS
or device that will host the hub,
follow the appropriate procedure listed below:
Smart-
UPS
®
a Shut down and power off the connected equip-
ment.
b Press and hold the UPS’s Power Off button
until you hear a click or until the UPS’s power
LED extinguishes.
c Unplug the
UPS from the AC power outlet
.
d Press and hold the UPS’s Power Off button
until you hear a click (hold for at least 5 sec-
onds).
Continued on next page