Broadband Automatic Disconnect Switch User Manual 7
Installation
Hardwire the Automatic Disconnect Switch
Step
• Remove the utility wiring panel located on top of unit.
• When required apply a strain relief grommet to the utility wiring panel
holes.
Step
• Route the building wiring through the holes in the
utility wiring panel.
• Connect the 220 V building wiring to the Input
Hardwire terminal block.
Step
• Route the input wiring for the FRP/FLM through the
hole in the utility wiring panel.
• Connect the FRP/FLM input wiring to the Output
Hardwire terminal block.
Step
Reinstall the utility wiring
panel. Secure the panel with
the screw removed in Step .